![]() ![]() Since October 2015 there is the last and therefore current Garmin USB driver with the version 2.3.1.2 and this replaces all previous Garmin USB drivers. The installation guide is based on a revised version of this website by Kurt Löffler from Vienna. Operating system WinXP with SP3 or WinVista.Memory stick 8…256 MB (512 MB are not supported).Garmin USB Data Card Programmer (USB 1.0).The following conditions must be met in order to use the USB Data Card Programmer under MapSource: The correct installation of the driver for the USB Data Card Programmer is error-prone, since several drivers have to be loaded one after the other in the correct order. The memory stick is not integrated as a normal drive in Windows. However, you have to keep one thing in mind. With newer operating systems such as Win7, Win10 or Win11, the old 32-bit drivers no longer work and you have to use one of the two old operating systems. In order for MapSource to be able to recognize the USB card reader, special drivers are required which are only available for WinXP and WinVista. But there were also writable memory sticks to which you could transfer sea charts yourself with the help of a USB card reader and the Windows software MapSource. Back then, Garmin offered sticks with nautical charts that could only be read. The stick consists of two memory modules that have a 16-bit data interface and can exchange data with the electronics of the plotter. The memory sticks are available in sizes from 8…512 MB. Garmin used a proprietary nautical chart memory stick called the BlueChart G1 for its old plotters. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |